Why Does One Galaxy Bud Dies Faster

0
One Galaxy Bud Drains Faster

Lately, there was a debate going on the Reddit that if the left Galaxy Bud drains quicker than the right one. Technically, one would be sure enough to say that it can’t be true.

However, some Galaxy Buds users are now complaining that one of their Galaxy Buds is draining quicker than the other one.

That doesn’t suggest that the debate on Reddit has its concrete conclusion. It could be the right Galaxy Bud draining quicker than the left and vice versa. This article will instead focus on explaining the solutions if one of your Galaxy Buds starts draining quicker than the other one.

Why Does One Galaxy Bud Dies Faster

1. One Galaxy Bud Is Being Used More

It’s likely because of the physical battery in the device. One reason why one of your Galaxy Buds drains faster than the other is that you’ve been using that Galaxy Bud more.

Sometimes you might leave an Galaxy Bud in for a phone call or listen to music with one. Doing this causes one Galaxy Bud to lose battery faster than the other. Sometimes one Galaxy Bud still loses batter faster than the other even when it’s not used.

Using one a lot more than the other will cause it to have more cycles and cause the battery to deteriorate faster. Unfortunately, the batteries on Galaxy Buds tend to die after 1 and 1/2 years, and the batteries are essentially unreplaceable. It might also be that you keep one plugged in far too much, causing the battery to deteriorate from always being connected to power.

2. Cases Data Port Is Dirty Or Damaged

One reason why one Galaxy Bud loses battery faster than another might simply be because one side of the Galaxy Buds case is damaged which means that one side gets charged less which can make it appear as if it drains faster, when in fact it just gets charged less.

Over time, lint and other dirt particles can get stuck in your case’s data ports where the Galaxy Buds are housed and this can prevent it from charging when you put you connect your cable. Cleaning the data port is simple but if one Galaxy Bud still won’t charge as much the other after that, it’s likely that the data port is fully damaged.

3. Software Issue

Another reason why one of your Galaxy Buds or Galaxy Bud Pro isn’t losing charge faster than the other is because of a software issue. There could be a bug that’s causing a failure in the operating system which is preventing the case from being charged. To remove this bug, a hard reset will need to be carried out so that the system can be refreshed and the software problem can be removed.

4. You May Notice That One Side Always Has Less Charge

When you take your Galaxy Buds out of their case after charging them, you’re shown the battery percentage of both Galaxy Buds. If you can see that one Galaxy Bud has less charge than another, then it’s clear to say that there’s a problem with the port for that Galaxy Bud. Since the port is damaged, it may cause issues when it comes to charging that specific Galaxy Bud.

5. One Galaxy Bud is Unable to Charge to 100%

If one Galaxy Bud isn’t charging to 100 percent each time you check on your phone, then this could be down to the port that houses that Galaxy Bud being damaged due to a short circuit.

You might find that your Galaxy Buds only charges a certain percentage but it never reaches 100%. The best solution would be to replace your Galaxy Bud case since it’s unable to charge one of your Galaxy Buds properly.

6. Is It Your Left Galaxy Bud Dying Faster Than Your Right

People tend to notice that it’s the left Galaxy Bud that dies faster than the right. It may be the case that people tend to favor using their left Galaxy Bud more than their right which has caused there to be a problem with the left one specifically.

How to Know If One Of Your Galaxy Buds Ports is Damaged?

If you want to know if one of your Galaxy Buds charging ports is damaged, wait till both of your Galaxy Buds are completely dead. Then you need to place both your Galaxy Buds in the case at the same time and wait for a while. After a while, lift the case and check your phone.

If you notice that one of the Galaxy Buds has less battery than the other, then it’s safe to say that side of the charging system in your case is damaged. After repeating this 3 times, you should know for sure if there’s a problem with one side of your Galaxy Buds in the case. Another to know is simply if every time you’ve charged them, one Galaxy Bud is always quick to die while the other one lasts much longer.

How to Fix One Galaxy Bud Is Draining Faster Than The Other

1. Don’t Use One Galaxy Bud More Than The Other

One of the most common reasons why one Galaxy Bud would drain faster than another is if one Galaxy Bud is used more than the other. If you notice that you constantly have one Galaxy Bud in and it cause the battery to drain faster than the other, then you’ll know that this is the cause of the problem.

Make sure that both Galaxy Buds are in at all times and even if you take one out, don’t put it back case because it will start charging – if it doesn’t charge, the battery will still remain meaning that the side that you constantly use will always have more charge.

2. Drain that Galaxy Bud Fully and then Charge:

If one of your Galaxy Buds is draining quicker than the other then you can try draining the battery of weaker Galaxy Bud until it is completely dead. Once it is dead, put it on charge and let it be fully charged prior to using it.

You can also drain both the Galaxy Buds fully and then charge them together to calibrate. Doing this will also address the issue in the weak Galaxy Bud.

3. Reset the Galaxy Buds:

Again, this solution is not specific to a single Galaxy Bud, but it will likely get the job done for the weaker Galaxy Bud. All you need to do is to put your Galaxy Buds back in the charging case.

  1. Ensure there is at least a 50% battery charge left in your Galaxy Buds.
  2. Press and hold the sensors on Galaxy Buds for up to 10 seconds.
  3. Put the Buds back into the case.
  4. Let it cool for 30 seconds.
  5. Check If One AirPod drains faster than the other

4. Inspect the Charging Port

You want to go through the ports and check that they’re not damaged in any way. For the side of the Galaxy Bud that keeps dying early, take a close look inside them for any debris or gunk that may have gotten in there that could be interfering with the charging process.

After inspecting the port, if you think you found anything that could prevent your Galaxy Buds from charging properly, don’t use a paperclip or anything sharp because that can cause problems with static electricity and it can do physical damage to your Galaxy Bud case or other components.

To clean out any debris from the port, use an anti-static brush. If you don’t have an anti-static brush lying around somewhere, which most people don’t, the next best thing you can use is a new toothbrush. Before you use a toothbrush, make sure that it has no moisture since this can cause serious damage to the internal components of your case. Make sure you gently brush out using a circular motion.

5. Un-pair and Reconnect:

If resetting Galaxy Buds didn’t help the cause then you should consider un-pairing the Galaxy Buds from your device and reconnecting them from scratch.

Here is what you need to do.

  1. Go to the Settings on your Samsung.
  2. Select Connected devices or Device Connection.
  3. Select Previously connected devices or Bluetooth.
  4. Tap your Galaxy Buds
  5. Now choose the option Forget.
  6. Doing this will un-pair the Galaxy Buds from the device.
  7. Now the first part of un-pairing is done. Next, you need to put the Galaxy Buds in the charging case and make sure they are fully charged. Reconnect your Galaxy Buds by following the given steps.
  8. Connect your Galaxy Buds again.

6. Get the Galaxy Buds Replaced:

Since replacing your Galaxy Buds is the fix you probably didn’t want to hear, if you’ve found that your Galaxy Buds are damaged, you’ll need to get them replaced.

You can replace your Galaxy Buds with the new Galaxy Buds Pro (view on Amazon). It’s more reliable and doesn’t have issues like the first generation of Galaxy Buds. Upgrading your Galaxy Buds to new versions will eliminate the battery-draining problems you’re experiencing.

7. Suck Out The Galaxy Bud Ports

Now this one might sound weird, but one thing that could help with this problem is to suck out the Galaxy Bud ports on your case. The case’s ports can be filled with all sorts of junk and one way to easily get rid of debris that could be trapped inside there is to suck it out. To do this, you just need to plug the ports with your mouth and such hard. This works well if you don’t have any compressed air to blow it out.

8. Contact Samsung Support

If you have tried all the steps and one Galaxy Bud still drains faster than the other, then it looks like there’s a deeper issue that can’t be resolved with troubleshooting steps. In this case, you’ll need to contact Samsung support to get this fixed.

This is likely to happen after many years of having your Galaxy Buds so don’t be taken back by the unfortunate situation. After about 3 years of having Galaxy Buds, whether that’s the Pro or the first-gen, problems start to occur. Usually, this is with the Galaxy Buds themselves but problems can still occur with the case.

Most Galaxy Buds have a full-year warranty so if you have to take them to the Samsung store, you will most likely get them replaced for free. On the website when it comes to selecting the problem that you have with your Galaxy Buds.

9. Update Your Galaxy Buds Firmware

Firmware is the software that is placed in your Galaxy Buds and you can update it to get rid of problems such as one Galaxy Bud losing battery quicker than the other. Having old firmware can cause charging problems so it’s best to keep things up to date. Your Galaxy Buds firmware should be up to date and this should be done automatically, but if it’s not, then you can do it manually using a very straightforward process.

If you want to update them, make sure they’re first connected to the device then you want to plug the charger into the case and close it. Once this is done you need to leave the Galaxy Buds overnight and wait for them to update. Unfortunately, there’s no other manual step that you can carry out to update them so you’ll just have to wait.

David Johnson is a freelance writer with 9 years of experience writing for Techzillo and other established tech outlets like iMore. His focus and key interests are Apple and accessibility as well as consumer technology in general. Read our Editorial Guidlines and Fact Checking process.

LEAVE A REPLY

Please enter your comment!
Please enter your name here